home 
wiki
wiki
Mast
Todo
16/04/2004
The Mast page, and nothing's here!
Feel free to add or expand on the content. Mast101 was the only mast page found on the old wiki, it is now included below.
Content suggestions...
Hockey stick (description)Free standing towers (description)
Telescopic masts (description - see below mast101)
Safety (Power lines and how not to destroy a node's owner)
...
Notes to add to Mast101 (below)
1.mounting a mast on the peak of your roof galv/tile3.mounting on a flat roof galv/decking
4.mounting in a roof and thru a tile
6.what a guy plate looks like and how to make sure they do there job
Mast101
NodeAFH's guide to putting up a mast on a tiled roof, so that you can get a better LOS for wireless (this is due to the fact that thetron doesn't have a idea)Mounting a mast on the peak of your roof galv/tile
Please note local laws may vary but odds are its 3 meters from the peak ofyour roof or 10 meters from the ground, which ever is higher
First we need the following equipment
a mast
a peak roof plate
up to 30/60 meters of guy rope (or washing line wire)
a/2 locking ring
a/2 guy plate
4 'O' end big ass screws
2-4 people
4/8 eye hook's
first get the plate in position and put the locking ring on with the guy
plate on the top end. If its a 3 meter mast you want the locking ring 2
meters up the pole, from 3-5 meter masts you want it at the 3 meter point,
at 6 meters you want it at the 3 and at the 5.5 meter points
example 1
<picture>
ok now we work out where on the roof it will be and find 4 points suitable
for you to drill to install the 'O' end big ass screws.
Rather than drilling through the tiles the eyebolts can be screwed in at an angle, into the last baton. This baton holds the last tile up and has the gutter attached to it.
How to do guy ropes/wires
After installing them you want to cut guy rope thats a bit longer than you need for each run, 4X7 meter runs will be fine for the lower set of guy ropes the upper ones you will probably want 4X9 meter ones. Now twist the ends through the holes on the guy plates.
If doing a longer pole you might want to just do the lower one first and get it all working then do the upper ones by repeating the steps.
Mast Raising
Get a person to hold the pole where you want it to to be and get the rest of the people to grab a wire and goto the 'O' end big ass screws you already have installed.Put the guy wire thru the eye hooks 'O' end while its hook end is on the 'O' big ass screw make sure its loose enough that you can unhook it but after you tighten it up that the guy rope is so tense that the mast doesnt move.
Do all 4 then repeat the step and BAM to take down untension them and you can lower and then add an antenna
<add some more pics>
Version 1 (old) modified Mon, 26 Jul 2021 12:49:29 +0000 by tyson
[EditText] [Spelling] [Current] [Raw] [Code] [Diff] [Subscribe] [VersionHistory] [Revert] [Delete] [RecentChanges]