home 
wiki
wiki
Spelling: NodeGHO-Configs
These are the configurations for the Linksys WRT54GS that is acting as
Node GHO's router.
The Firmware is OpenWRT [1], precompiled squashfs snapshot from the
OpenWRT [2] website dated 25 May 2005.
Once the firmware had loaded the NVRAM was cleared and set to
defaults using the _mtd erase nvram & overflow: auto; border: 1px
solid; padding: 3px;">
root@nodegho:~# ifconfig eth0 Link encap:Ethernet HWaddr
00:0F:66:C5:2A:D8 UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500
Metric:1 RX packets:566116 errors:0 dropped:0 overruns:0 frame:0 TX
packets:529242 errors:0 dropped:0 overruns:0 carrier:0 collisions:0
txqueuelen:1000 RX bytes:108273473 (103.2 MiB [4]) TX bytes:99490914
(94.8 MiB [5]) Interrupt:5 Base address:0x2000
eth1 Link encap:Ethernet HWaddr 00:0F:66:C5:2A:DA inet
addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST
RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0
overruns:0 frame:2230678 TX packets:225 errors:0 dropped:0 overruns:0
carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX
bytes:11250 (10.9 KiB [6]) Interrupt:4 Base address:0x1000
lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP
LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:92 errors:0 dropped:0
overruns:0 frame:0 TX packets:92 errors:0 dropped:0 overruns:0
carrier:0 collisions:0 txqueuelen:0 RX bytes:10158 (9.9 KiB [7]) TX
bytes:10158 (9.9 KiB [8])
vlan0 Link encap:Ethernet HWaddr 00:0F:66:C5:2A:D8 inet
addr:10.10.129.1 Bcast:10.10.129.15 Mask:255.255.255.240 UP BROADCAST
RUNNING MULTICAST MTU:1500 Metric:1 RX packets:204323 errors:0
dropped:0 overruns:0 frame:0 TX packets:264039 errors:0 dropped:0
overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:41708299 (39.7
MiB [9]) TX bytes:48395231 (46.1 MiB [10])
vlan1 Link encap:Ethernet HWaddr 00:0F:66:C5:2A:D8 inet
addr:10.10.130.177 Bcast:10.10.130.191 Mask:255.255.255.240 UP
BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:218776
errors:0 dropped:0 overruns:0 frame:0 TX packets:111202 errors:0
dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX
bytes:23721101 (22.6 MiB [11]) TX bytes:20042223 (19.1 MiB [12])
vlan2 Link encap:Ethernet HWaddr 00:0F:66:C5:2A:D8 inet
addr:10.10.131.65 Bcast:10.10.131.79 Mask:255.255.255.240 UP BROADCAST
RUNNING MULTICAST MTU:1500 Metric:1 RX packets:143017 errors:0
dropped:0 overruns:0 frame:0 TX packets:119278 errors:0 dropped:0
overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:32653985 (31.1
MiB [13]) TX bytes:28231018 (26.9 MiB [14])
vlan3 Link encap:Ethernet HWaddr 00:0F:66:C5:2A:D8 inet
addr:10.10.131.81 Bcast:10.10.131.95 Mask:255.255.255.240 UP BROADCAST
RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0
overruns:0 frame:0 TX packets:17368 errors:0 dropped:0 overruns:0
carrier:0 collisions:0 txqueuelen:0 RX bytes:0 (0.0 B) TX
bytes:1411800 (1.3 MiB [15])
vlan4 Link encap:Ethernet HWaddr 00:0F:66:C5:2A:D8 inet
addr:10.10.131.97 Bcast:10.10.131.111 Mask:255.255.255.240 UP
BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0
dropped:0 overruns:0 frame:0 TX packets:17355 errors:0 dropped:0
overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:0 (0.0 B) TX
bytes:1410642 (1.3 MiB [16])
root@nodegho:~#
NVRAM VARIABLES
aa0=3
ag0=255
boardflags2=0
boardflags=0x0388
boardnum=42
boardrev=0x10
boardtype=0x0101
boot_ver=v3.1
boot_wait=on
ccode=0
cctl=0
clkfreq=200
dl_ram_addr=a0001000
et0macaddr=00:0F:66:C5:2A:D8
et0mdcport=0
et0phyaddr=30
gpio2=adm_eecs
gpio3=adm_eesk
gpio5=adm_eedi
gpio6=adm_rc
il0macaddr=00:0f:66:c5:2a:da
lan_dns=192.168.1.2
lan_gateway=
lan_ifname=eth1
lan_ifnames=
lan_ipaddr=192.168.1.1
lan_netmask=255.255.255.0
lan_proto=static
os_flash_addr=bfc40000
os_ram_addr=80001000
pa0b0=0x170c
pa0b1=0xfa24
pa0b2=0xfe70
pa0itssit=62
pa0maxpwr=0x48
pmon_ver=CFE 2004.1.30.0
port0_ifname=vlan0
port0_ipaddr=10.10.129.1
port0_netmask=255.255.255.240
port0_proto=static
port1_ifname=vlan1
port1_ipaddr=10.10.130.177
port1_netmask=255.255.255.240
port1_proto=static
port2_ifname=vlan2
port2_ipaddr=10.10.131.65
port2_netmask=255.255.255.240
port2_proto=static
port3_ifname=vlan3
port3_ipaddr=10.10.131.81
port3_netmask=255.255.255.240
port3_proto=static
port4_ifname=vlan4
port4_ipaddr=10.10.131.97
port4_netmask=255.255.255.240
port4_proto=static
scratch=a0180000
sdram_config=0x0022
sdram_init=0x0008
sdram_ncdl=0x22
sdram_refresh=0x0000
sromrev=2
vlan0hwname=et0
vlan0ports=0 5
vlan1hwname=et0
vlan1ports=1 5
vlan2hwname=et0
vlan2ports=2 5
vlan3hwname=et0
vlan3ports=3 5
vlan4hwname=et0
vlan4ports=4 5*
wan_hostname=nodegho
watchdog=5000
wifi_ifname=eth1
wifi_ipaddr=
wifi_netmask=
wifi_proto=none
wl0_afterburner=auto
wl0_antdiv=-1
wl0_ap_isolate=0
wl0_auth=0
wl0_auth_mode=open
wl0_bcn=100
wl0_channel=6
wl0_closed=0
wl0_corerev=7
wl0_country=
wl0_country_code=AU
wl0_crypto=tkip
wl0_dtim=1
wl0_frag=2346
wl0_frameburst=off
wl0_gmode=6
wl0_gmode_protection=auto
wl0_hwaddr=00:0F:66:C5:2A:DA
wl0_ifname=eth1
wl0_infra=1
wl0_key1=
wl0_key2=
wl0_key3=
wl0_key4=
wl0_key=1
wl0_lazywds=0
wl0_maclist=
wl0_macmode=disabled
wl0_mode=ap
wl0_net_mode=mixed
wl0_phytype=g
wl0_phytypes=g
wl0_plcphdr=long
wl0_radio=1
wl0_radioids=BCM2050
wl0_radius_ipaddr=
wl0_radius_key=
wl0_radius_port=1812
wl0_rate=0
wl0_rateset=default
wl0_rts=2347
wl0_ssid=snarf
wl0_unit=0
wl0_wds=
wl0_wep=disabled
wl0_wpa_gtk_rekey=3600
wl0_wpa_psk=
wl0gpio2=0
wl0gpio3=0
wl0id=0x4320
wl_country_code=AU
INSTALLED PACKAGES
http://openwrt.org/downloads/experimental/bin/packages/ntpclient_2003_194-1_mipsel.ipk
http://openwrt.org/downloads/experimental/bin/packages/quagga_0.98.3-1_mipsel.ipk
http://openwrt.org/downloads/experimental/bin/packages/quagga-ospfd_0.98.3-1_mipsel.ipk
http://openwrt.org/downloads/experimental/bin/packages/quagga-zebra_0.98.3-1_mipsel.ipk
http://openwrt.org/downloads/experimental/bin/packages/kmod-sched_2.4.30-1_mipsel.ipk
http://openwrt.org/downloads/experimental/bin/packages/tc_2.6.9-1_mipsel.ipk
http://openwrt.org/downloads/experimental/bin/packages/libpthread_0.9.27-1_mipsel.ipk
http://reseaucitoyen.be/diskless/openwrt/feeds/stable/libcpp_5.0.5-1_mipsel.ipk
http://reseaucitoyen.be/diskless/openwrt/feeds/stable/iperf_1.7.0-1_mipsel.ipk
/ETC/QUAGGA/OSPFD.CONF
hostname nodegho password **** enable password **** log syslog !
interface eth1 ! interface vlan0 ! interface vlan1 ! interface vlan2 !
interface vlan3 ! interface vlan4 ! ! router ospf ospf router-id
10.10.129.1 network 10.10.129.0/28 area 0.0.0.0 network
10.10.130.176/28 area 0.0.0.0 network 10.10.131.64/28 area 0.0.0.0
network 10.10.131.80/28 area 0.0.0.0 network 10.10.131.96/28 area
0.0.0.0 passive-interface eth1 !
Note that there is no need for a _redistribute_ statement here as
all connected networks have already been declared with _network_
statements. The internal wireless interface, eth1, has been prevented
from participating in OSPF with the _passive-interface_ statement.
/ETC/INIT.D/S40NETWORK
(network initialisation script)
#!/bin/sh . /etc/functions.sh case "$1" in start|restart) # ifup lan
# ifup wan ifup port0 ifup port1 ifup port2 ifup port3 ifup port4 ifup
wifi wifi up ifup lan
wlc eth1 qtxpwr 12 #internal wireless to low power
for route in $(nvram get static_route); do { eval "set $(echo $route
| sed 's/:/ /g')" $DEBUG route add -net $1 netmask $2 gw $3 metric $4
dev $5 } done ;; esac
Links:
------
[1] http://melbournewireless.org.au/?OpenWRT
[2] http://melbournewireless.org.au/?OpenWRT
[3] http://melbournewireless.org.au/?OpenWRT
[4] http://melbournewireless.org.au/?MiB
[5] http://melbournewireless.org.au/?MiB
[6] http://melbournewireless.org.au/?KiB
[7] http://melbournewireless.org.au/?KiB
[8] http://melbournewireless.org.au/?KiB
[9] http://melbournewireless.org.au/?MiB
[10] http://melbournewireless.org.au/?MiB
[11] http://melbournewireless.org.au/?MiB
[12] http://melbournewireless.org.au/?MiB
[13] http://melbournewireless.org.au/?MiB
[14] http://melbournewireless.org.au/?MiB
[15] http://melbournewireless.org.au/?MiB
[16] http://melbournewireless.org.au/?MiB
[EditText] [Spelling] [Current] [Raw] [Code] [Diff] [Subscribe] [VersionHistory] [Revert] [Delete] [RecentChanges]