home 
wiki
wiki
Spelling: DWL-900AP
DLINK 900-AP
HACKING
Note! Everyone who understands what this does thinks the 900-AP hack
is A BAD IDEA.
Have a look at http://www.maokhian.com/wireless/wap11.html for more
details.
Firstly, you can get the 1.4j1 firmware from this page.
http://www.seattlewireless.net/index.cgi/Wap11Hack
Also the atmel snmp config utility which will allow you to adjust the
output power. (see instructions on that page)
Also, the linksys wap11 USB config allows for individual tx and rx
diversity setting which is handy if you intend to mast mount one of
these babies!
ftp://ftp.linksys.com/pub/network/wap11sw.exe
These are much nicer config tools to use than the dlink versions!
DUAL ANTENNAS
FYI, the RP-SMA [1] is attached to the 'Left' output. The 2 antennas
are for diversity, as you can see the internal one is pretty lame, but
you'll need to disable it for external links.
Vak suggested to me that the best way to do this was to remove it
altogether and replace it with a resistor of something like 50 ohms.
Don't leave it unconnected without the resistor as you may damage the
output amplifier.
WEATHERPROOF HOUSING
Weatherproof dlink 900AP [2]
FIRMWARE
Firmware [3]
Links:
------
[1] http://melbournewireless.org.au/?RPSMAConnector
[2] http://www.wiresncode.com/projects/wireless/dlink/
[3]
http://melbournewireless.org.au/ftp://ftp.dlink.com/Wireless/DWL900AP/Firmware/
[EditText] [Spelling] [Current] [Raw] [Code] [Diff] [Subscribe] [VersionHistory] [Revert] [Delete] [RecentChanges]