home 
wiki
wiki
Spelling: ConfigsZebraOspfd
BACKBONE ROUTER
These configurations are illustrative only. IP addresses will
obviously need to be changed. Configurations from Zebra 0.92a. Have
not yet been tested. tunl0 will need creation from shell using ip
tunnel etc. Configurations for internal routers, and ASBR not yet
available. ASBR will be basically the same as below, with some
additional redistribute commands, potentially also with bpgd.conf.
If you have the following message appear:
[[root@fartlek etc]# zebra -d 2002/05/15 22:45:24 ZEBRA: can't create
router advertisement socket: Address family not supported by protocol
There is no such command. Error occured during reading below line.
ipv6 nd suppress-ra
then you don't have IPv6 support. Try modprobe ipv6.
ZEBRA.CONF
! ! Zebra configuration saved from vty ! 2002/04/15 23:38:48 !
hostname zooropa password secret enable password secret log file
zebra.log ! interface lo ipv6 nd suppress-ra ! interface sit0 ipv6 nd
suppress-ra ! ! eth0 is wireless LAN link one !interface eth0 ip
address 172.16.80.1/23 no ipv6 nd suppress-ra ! ! eth1 is wireless LAN
link two for local hosts interface eth1 ip address 10.10.1.1/28 no
ipv6 nd suppress-ra ! interface ppp0 ipv6 nd suppress-ra ! ! a tunnel
interface to emulate a hoped for wireless connection over Internet
interface tunl0 ipv6 nd suppress-ra ip address 172.16.80.2/23 line vty
OSPFD.CONF
! ! Zebra configuration saved from vty ! 2002/04/17 01:05:48 !
hostname zooropa password secret enable password secret log stdout ! !
! interface lo ! ! the WAN wireless, IBSS mode, must use
point-to-multipoint interface eth0 ip ospf network point-to-multipoint
! ! the local host wireless - no config needed, doesn't run OSPF
interface eth1 ! interface sit0 ! ! our Internet tunnel interface
tunl0 ip ospf network point-to-point ! router ospf ! the router-id is
the lowest of the assigned 172.16 space addresses ! maybe generate
automatically? ospf router-id 172.16.80.1 ! redistribute connected
routes, eg. to the 10.10.1.1/28 that is configured ! in zebra
redistribute connected ! this is the network that all backbone routers
must agree as being area 0 network 172.16.80.0/23 area 0 ! line vty ![EditText] [Spelling] [Current] [Raw] [Code] [Diff] [Subscribe] [VersionHistory] [Revert] [Delete] [RecentChanges]