RFC1163

! BGPD.conf
!-*- bgp -*-
!
!BGPd sample configuratin file
!
hostname bgpd
password XXXX or zebra
!enable password please-set-at-here
!
!bgp mulitple-instance  -? only if you need to run BGPD more than once Unlikely  on mw.
!
router bgp 7675  -? your routers ASN Should be with in this range 64512 to 65534 and connot be the same as another routers in this situation.
bgp router-id 10.10.129.145 -? this is your routers id most likey the same as in your ospf.conf
redistribute ospf -? this will redistribute routes collected by ospfd to bgpd
redistribute connected -? This  will distribute Directly connected networks to bgp
!DAN'S COMMENT: be careful using redistribute connected - you don't want to
!distribute your local area network subnet onto the melbwireless network!
!bgp should automaticlly distribute routes covered by the network statement
network 10.10.0.0/16 -? you can use this for mw or add each subnet that you are
!connected to i.e: 1network 0.10.128.0/28 network 10.10.129.144/29 and so on
neighbor 10.10.128.97 remote-as 7676 -? for each router on the a subnet that is running bgp will have its own ip(duh!) and its own asn you will need to add a line for each router and there asn here.
!
!access-list all permit any most likely you will not need any access list unless you need to.
!
!The debug section is optional.
debug bgp events
debug bgp filters
debug bgp fsm
debug bgp keepalives
debug bgp updates
!log file bgpd.log
!
log stdout

!-*- bgp -*-
hostname bgpd
password zebra
!enable password please-set-at-here
!
router bgp 64512
bgp router-id 10.10.128.1
redistribute ospf
network 10.10.0.0/16
neighbor 10.10.128.3 remote-as 64513
neighbor 10.10.128.5 remote-as 64515
neighbor 10.10.128.7 remote-as 64517
neighbor 10.10.128.8 remote-as 64518
!
!log file bgpd.log
!
log stdout